Extract Design from Image
Extract design from image: upload a photo of a printed shirt, mug or bag, confirm the detected design area, and get the flat artwork lifted off the product.
- 1Your photo is uploaded and the printed design is detected automatically.
- 2Check the box. Drag it, or pull a corner, until it frames the whole design.
- 3Get the artwork back as a flat, transparent PNG you can download.
The boxed area is redrawn as flat, front-on artwork on a transparent background: about a minute at 1K, about 3 minutes at 2K or 4K, which are enlarged for print.
Without an account, 1K runs are free up to today's limit.
- Use only photos of designs you own or have the rights to reuse. Lifting someone else's artwork does not give you the right to sell it.
- Your photo is stored temporarily so the AI service can process it.
- Without an account, the four AI design tools share a daily allowance of free 1K renders, reset at midnight UTC. Signed in, each run spends credits. Uploading and detecting the design are free, with their own daily limits.
About the Extract Design from Image
Recover artwork from a product photo
Original files go missing for ordinary reasons: an old laptop fails, a freelancer only ever sent a mockup, or an early design survives only as a photo of the first shirt you printed. This tool lets you extract design from image files of printed products. You upload the photo, confirm the box the tool draws around the design, and it returns the flat artwork lifted off the fabric or ceramic, ready to clean up and use again.
When it helps
- Lost source files: rebuild a design you made years ago from a photo of the finished product.
- Mockup only: pull your own artwork out of a mockup when the separate design file is gone.
- New products: move an existing design from a tee to a mug or tote without starting from scratch.
- Detail images: show the artwork on its own next to the product photo in a listing.
An example
Imagine your best-selling sweatshirt design was drawn in 2021 and the only copy left is a photo of a sample hanging on a door. Upload that photo, adjust the detected box so it covers the whole print and none of the collar, and run the extraction. You get a flat, front-facing version of the design with the fabric folds and uneven light smoothed out. From there you can tidy small flaws, rebuild the lettering if it needs it, and check the pixel size before sending it to print.
Rights come first
This is a recovery tool for artwork you own. Only upload photos of designs you created or are licensed to reproduce. Pulling a design off someone else's product gives you no right to sell it, and listing copied artwork can lead to listings being taken down. The extraction is AI-generated, so fine lines and small text may be redrawn rather than copied exactly. Free daily renders are included. Sellers describe this job in different ways, such as extract design from t-shirt photo, get a design off a shirt or turn a product photo into a PNG; the steps are the same for each, and the result is a starting file you can refine and print again.
How to read the results
The tool works in two steps: detection, then extraction.
- The design box. After upload, a box marks the area the tool believes holds the design. Drag it so it covers the full print with a small margin. A box that is too tight crops the artwork; one that is too loose pulls in seams and shadows.
- The extracted artwork. Compare it with the photo. Shapes and colors should match, and any text should read and be spelled as on the original.
- Distortion. Prints on curved mugs or creased fabric are harder to flatten. If the result looks stretched, use a photo taken straight on, with the product lying flat and evenly lit.
- Background. If the artwork comes back on a fabric-colored block, run it through a background remover to get a transparent file.
Treat the output as a strong starting point rather than a finished print file. Check its pixel size against the print area you plan to use, and redraw any lettering that came out soft.